Gelcoat Catalyst for activating gelcoats and Polyester Resins

NOTE : Gelcoat and Catalyst can only be shipped to the UK.

Mix Ratio: 2% catalyst for use with gelcoat.

Use 6 drops into 10ml of resin. (As a guide 1 UK tablespoon = 14.2ml)

Curing: At 15C pot life is approx 15 mins, repair cure 1-3 hours

At higher temps, cure times will be reduced and colder, will be slower. Never work on surfaces colder that 5C

Do not allow the resin or catalyst to freeze.

Preparation: All surfaces must be clean and dry, free from loose material. Roughen area thoroughly and degrease with pure acetone.

Wear protective clothing, and keep all work warm and dry.

Always read the product labels.

Catalyst should be treated with special care: it is inflammable and corrosive - do not let it contact the skin, mouth or eyes. Should it do so, wash from the skin immediately under running water. If it contacts the eyes, flush them under running water for at least 15 minutes and obtain medical attention.

Materials Safety Data Sheet

The Materials Safety Data Sheet (MSDS) for this product can be found at this Rooster Website page: Materials Safety Data Sheets – ROOSTER UK (roostersailing.com) (This is a complete library of all MSDS related to Rooster products).